6 B U R L E Y T R A I L E R O W N E R ’S I N S TR U C T I O N A N D S A FE T Y M A N UA L
Mounting the Reectors
Nomad
™
: The reector brackets mount on the outside rear of each side
panel, 2.5” up from the plastic connector on the side panel. (The holes
for the mounting screws are covered by the fabric.)
To mount the bracket, insert a self-tapping bracket
screw through the hole in the curved section of the
reector and drive the screw through the fabric,
into the hole in the rear side panel frame. (This
does not harm the fabric.) Then mount the reector
onto the bracket with the reector screw. Repeat for
the bracket and reector on the other side panel.
See illustrations.
Flatbed
™
: The reectors are mounted to the reector
brackets on the rear of the main frame tube. Snap
the posts on the reectors into the openings in the
brackets, and with the provided screws, screw the
pieces together. Tighten the screws snugly, making
sure the reector faces away from the trailer.
Attaching the Wheels
First, verify that the tires are inated to 30-35 P.S.I.
Tip the trailer frame onto its rear end.
Nomad
™
: With the quick-release lever in the “OPEN” position, insert the wheel
axle assembly completely into the hollow trailer axle, making sure that the
horizontal shaft goes all the way into the axle. Once the wheel is fully seated
in the hollow axle, position the quick-release lever so that it is aimed to the
rear of the trailer in the “CLOSED” position (the lever is marked for OPEN or
CLOSED positions). Repeat
for the other wheel.
2.5”
Right
rear
Comments to this Manuals